How to Re-Sow Your Lawn

If your lawn is old and tired, or you are struggling to control weeds, disease or pests because the soil is poor, you may decide to kill it off and start a new lawn.

Kill the Existing Lawn

Particularly if you have been struggling with weeds it is important to effectively kill all the weeds to the roots so that they don’t come up again in your new lawn.

Spray the whole lawn with Kiwicare Weed Weapon Extra Strength plus Dye & Stick. This fast acting, systemic herbicide will kill the lawn grass and weeds (including coarse grass weeds) to the roots. Wait 3 weeks for the full death and if any new weeds appear or re-sprouting occurs, re-apply the Weed Weapon Extra Strength.

You can sow seed within a week of spraying with Weed Weapon Extra Strength.

Rake Off the Dead Weeds and Prepare the Soil

Using an Atlas Trade Scarifying Rake or strong braced garden rake, rake out the weeds and dead grass from your lawn.

Now there are some things you need to do the check the soil and make improvements:

  • Check the pH of the soil and adjust it with lime (raises pH) or sulphur (lowers pH) to get a soil of between pH 6.0 and 7.0

  • Check the soil type. Most soils are mixtures of all three particle sizes but in varying proportions. A predominance of sand particles makes a lighter, more open soil with good drainage and aeration. Minute clay particles pack together tightly making a clay soil heavier, denser, and with less favourable air and water penetration. If you have a heavy clay soil add sand or use gypsum to help break the clay up and add a 8-10 cm layer of well-draining topsoil on top.

  • Check the level of your lawn. Look for hollows and dips and level these off with good topsoil using an Atlas Tools landscaping rake. These strong wide aluminium rakes make it easy to get a good even surface. Note: it is ideal to have a slight slope to your lawn so the water does not pool on the surface in heavy rain. On a very flat area dome the lawn slightly in the middle so heavy rains run off to the sides.

  • Use a taught string to check the level and slopes of your lawn and topsoil dressing.

Choose Your Seed

Most areas of New Zealand are suitable for a fine turf lawn. But there will be variations of sun and shade, likely wear and tear, and climate that might affect your choice of lawn seed. For the majority of fine turf lawns, a blend of grass types give the lawn ability to tolerate sun, shade, high wear and a broad range of climate. Kiwicare Lawnpro Smart Lawn Seed is an excellent blend and has the added benefits of seed with Aqua-Gel coating to ensure germination, even if you forget to water for a day or two. It also has included fertiliser for initial germination and establishment of the grass, and is a blend of creeping red fescue and perennial ryegrass which will thrive in sun, shade and is hard wearing.

Water and Prepare the Lawn for Sowing

Water the lawn gently but thoroughly, so the soil is wet deep down. A light water on the surface is not enough. Then let the water drain so the soil surface is not sticky and you can walk on it without making a mess.

Tamp down or stamp down the topsoil top dressing and then rake it lightly with your landscaping rake. You want the soil to be firm but the surface to be lose.

Sow the Seed

Sow your LawnPro Smart Seed at a rate of 40 g per m2, i.e. 1 kg will cover 25 m2. Then rake the soil lightly with your landscaping rake to ensure the seed is in good contact with the soil and water lightly. The seed needs warm moist soil and light to germinate. Water gently in the mornings. It is OK for the surface to dry out so long as there is moisture underneath.

Watch it Grow and When to Mow

The seed will germinate in about 7 days. Let it grow to around 5-8 cm tall before giving it its first light trim with a sharp mower. A blunt mower will damage the grass and may pull grass out that has not got fully developed roots.

Thereafter mow as needed but gradually lower the cutting height to about 3 cm, which is ideal. Do not remove more than 1/3 of the growth at any one time.

Maintenance

If weeds appear in your new lawn, spot treat them with LawnPro Turfclean at the young lawn rate. Only apply to whole lawns when they are at least 2 months old.

During periods with warm nights irrigate the lawn as necessary but do it in the morning so that grass blades dry during the day and are not damp through the night. This helps prevent fungal diseases.

Enjoy your new lawn!

11 views

© 2019 Amalgamated Hardware Merchants Limited